Peavey DPM C8p - 2.4 Range Soloing; 2.6 Keyboard Range Transposition

2.4 R ange Soloing
There are two methods of soloing ranges:
Method 1
1. Press and hold the Solo soft button.
2. Press the appropriate number button (1-8) to solo that range. An S will be shown above the keyboard
icon to indicate that there is a solo in effect.
3. Release the Solo soft button.
4. Press Solo to return to the previous mute status, or repeat steps 1-3 to solo another range. Pressing Solo
repeatedly will toggle between the mute status and the latest solo.
Meth<xl 2
1. Use the left/right directional buttons to move the range cursor to the range you want to solo.
2 Press the Solo soft button and release it without pressing any numerical buttons.
Note: The cursor position is saved with the preset. This will allow you, for example, to have the preset come
up with Range #8 highlighted to make it immediately available for soloing.
Caution: If you perform any mute operations, the solo status will be canceled.
SECTION 2B PRESET, RANGES SCREEN
The ranges screen accesses six range-related parameters, three additional pages, and allows saving the edited preset.
I ll III II III II III II III II ill II III II III
Rarge :1 Transpose i+dQ
Lo-Key :A0 Hi-Key ;A2
OuVChan :01 O'-ttBus :L-3-
2.5 Keyboard Range Selection
You can select the range to be edited in two ways.
m- Press the RngStep (Range Step) soft button. This increments to the next higher, active, range. Going
past 8 wraps around to Range 1.
«- Place the cursor on the Range parameter and select the desired range.
2.6 Keyboard Range Transposition
Each range can be transposed up to ±48 semitones.
Place the cursor on the Transpose parameter. I ,'se the input method of your choice (i.e., Inc/Dec buttons,
data slider, mouse or trackball, etc.) buttons to choose the desired amount of transposition in semitones.