Peavey DPM C8p - 2.13 Wheel and Pressure Assignment; 2.13 a Parameter Assignment; 2.13 b Polarity Assignment

SECTION 2C PRESET CONTROL ASSIGN SCREEN
This screen assigns MIDI controllers to the wheels, sliders, buttons, CV pedals, pressure and fcxjts wit dies,
and assigns polarity to all of them except the footswitches.
Upon pressing the CtlAsgn soft switch from the main preset screen, the wheel and pressure assignment page
appears. However, any control assignment page can be called from any other control assignment page. Also,
each control assignment page lets you save the preset (section 2D).
Note: Any C8 controller programmed to MIDI controller #7 (volume) will be scaled with the volume on the
Prg/Vol screen (section 2.10), thereby using that value as a maximum level. If the volume is set tc > OFF,
the unsealed value (0-127) will be sent. Any other (non-volume) MIDI controllers will be sent out
unsealed (0-127).
2 .13 Wheel and Pressure Assignment
Upon pressing the CtlAsgn soft switch from the main preset screen or the Wheel soft button on any other
controller assignment page, the following screen appears;
Wheel Pssiqn 01 Preset Name
Wheell
Wheel 2
Wheel 3
Press
Modulation Wheel-'Lever (0L>
Modulation Wheel-'Leoor (0L)
Foot Controller (041
Channel Pressure
Button I Foot IPolar I SfiUE
Wheel 1 assigns the pitch bend wheel, Wheel 2 the Mod 1 wheel, and Wheel 3, the Mod 2 wheel. These three
wheels are located to the left of the keyboard. Wheel 1 is center-detented, making them useful for applications
such as pitch bend and panning. Pressure assigns the keyboard pressure.
2 . 1 3a Parameter Assignment
Place the cursor over the parameter to be assigned and select the desired assignment. Options are OFF. MIDI
controllers 01-120 channel pressure pitch bend (hill range), pitch bend (up only) and pitch bend (down only).
Note: Wheel 1 cannot do a one-way pitch bend (either of the last two choices).
2 . 13b Polarity Assignment
Polarity' refers to the “sense” of the controller. To change polarity, press the Polarity soft button wli ile the cu rsor
is on the controller to be edited.
Example: With Mod 1 assigned to modulation and positive polarity, rotating the wheel away from you
increases the modulation from zero to full on. With negative polarity assigned, rotating the wheel away from
you decreases the modulation from full on to zero.