Peavey DPM C8p - 2.7 Keyboard Range Limits; 2.8 Keyboard Range Output Channel; 2.9 Keyboard Range Output Bus; 2.10 Range Volume;Program Change Settings

2.7 Keyboard Range Limits
Each range can be restricted to a specified contiguous group of keys. Ranges may'' overlap.
To set the low and high key limits for the selected range:
1. Place the cursor on the Lo-Key parameter, then press the key that defines the lower range limit.
2. Place the cursor on the Hi-Key parameter, then press the key' that defines the upper range limit.
A line will appear under the on-screen keyboard to show the selected range.
2.8 Keyboard Range Output Channel
Each range can transmit over its own MIDI channel. Place the cursor on the OutChan parameter and select
the desired MIDI channel, from 01 to 16.
2.9 Keyboard Range Output Bus
Each range can appear over any combination of the four individual MIDI outputs.
Place the cursor on the OutBus parameter and select which MIDI outputs the range data will appear over.
Combinations of outputs are selected in the following order:
OFF 1— -2— 12— -3- 1-3- -23- 123-
—4 1—4 -2-4 12-4 —34 1-34 -234 1234
2.10 Range Volume/Program Change Settings
Each range can send out an associated MIDI volume message, MIDI program change message, and MIDI
program change Bank message when a preset is recalled. Press the VoLPrg soft button from any screen on
which it appears to call up the following screen:
UolPrS: R anSe 1 of 81 Preset Name
PROGRAM On Patch Recall :12?
VOLUME On Patch Recall !0O0
BANK On Patch Recall :000(MSB:300)
[3BSB|
2.10a Selecting the Range to Be Edited
Press the RngStep soft button to increment to the next higher, active, range. Going past 8 wraps around
to Range 1.