Peavey DPM C8p - 6.4 Start;Stop;Continue

6.4 START/STOP/CONTINUE
These soft buttons cause an external sequencer to start, stop, and continue.
To cause an external sequencer to start, press Start. The C8 will then send timing clocks if Transmit Clocks
is in Play Only mode (in Always mode, docks are always being sent). The middle soft button turns to Stop,
which you press to stop the sequencer and in Play Only mode, causes the timing clocks to stop.
Also, either footswitch can be programmed to Ire a sequencer start/stop toggle. In this case, the footswitch
will have the same effect as the start and stop commands on the Sequence screen. Since the Sequence screen
has its own MIDI output bus (and since Start and Stop are not channel messages), all Range parameters
(including Enables) will Ire ignored when the footswitch is pressed.
Pressing Stop returns the soft buttons to Start and Cont. To restart the external sequencer from the beginning,
press Start. To continue the sequencer from where it was stopped, press Cont
6.5 SAVE PRESET
Press the SAVE soft button and refer to section 2D.