Peavey DPM C8p - 3.13 Load From Disk (C8 only); 3.14 Send SysEx Data in Buffer Through MIDI Out

2. Press the SAVE soft button. The file name and comment screen appears:
3. You can now name the file and add a comment about the file. Move the cursor over the character to
be changed and enter the new character using your favorite input method or the keyboard itself.
Characters appear in the ft >11< nving order (starting from the bottom of the keyboard or data slider, which
gives a blank character):
Upper case letters A-Z, lower case letters a-z, numbers 0-9, + - = ()*& A % $ # @ ! ~ ‘ !II 1 I * : ; ? /
Place the cursor on the Channelization parameter. Use your preferred input method to choose a channel from
01-16, or Off (input data is passed to the outputs without being channelized).
4. If the file name already exists, you will be asked if you want to overwrite. If yes, press SAVE again, and
the file will be overwritten. The disk directory screen will then return.
3.13 Load From Disk (C8 only)
The C8 can load the SysEx files saved to disk. To load:
1. Insert the disk containing the file to be loaded into the disk drive, then press the LOAD soft button. The
screen will show a directory of SysEx files on disk, and how much space is available on the disk.
2. Press the LOAD soft button. The file will be loaded into the C8.
3.14 Send SysEx Data in Buffer Through MIDI Out
SysEx data in the buffer can be sent out through MIDI. To do this:
1. Press the Send soft button on the Bulk Dump Functions screen.
BflBEHB
2. Select the output MIDI bus over which the SysEx data will be send by pressing the corresponding
soft button.