Peavey DPM C8p - Section 4 D: Pressure Curve Screen; 4.10 ROM Curves

4.9 Equal Power Curve on Ctrls
When this parameter is turned OFF, the CB's controllers (sliders, wheels, etc.) respond in a linear fashion.
When it is turned ON, a logarithmic-type curve is applied to all controllers except pitch bend. This can help
cure lack of volume in the mid-controller positions when crossfading.
SECTION 4C GLOBAL , CHAIN CREATION SCREEN
Presets can be arranged as a chain of up to 128 steps, and stepped through with the Chain Up/Down
foots witches. This is particularly useful for live performance.
PRESET CHQIN 4*1 EDIT
01 Preset Name
STEP PRESET
01 01 Preset Name
To select a chain, see section 4.3- To create a chain:
1. Place the cursor on the Step parameter and choose the desired step of the chain.
2. To insert a preset in the chain at the selected step, select the desired preset with the PROG+ and PROG-
soft buttons, then press the Insert soft button.
3. To delete a step from the chain, select the step to be deleted and press the Delete soft button. The other
steps “close up” (e.g., if you delete step 11, what was step 12 becomes step 11, what was step 13 becomes
step 12 , etc.).
To step through a chain, use the Program Chain Up switch to increment through the chain one step at a time,
or the Program Change Down switch to decrement through the chain one step at a time.
SECTION 4D PRESSURE CURVE SCREEN
This screen shows the global pressure curves that translates your aiieitouch force into MIDI messages. The three
parameters will allow you to tailor the response of the C8’s pressure controller to your own taste. The curve is based
on one of 17 curves stored in ROM, which is then customized with the scale and offset parameters.
PRESSURE CURUE
: 11
; + 000
:150*
4.10 ROM Curves
Use this parameter to choose one of the 17 different pressure curves stored in ROM. The graph shows the
relation of the MIDI output to input pressure.