Peavey DPM C8p - Chapter 3: MIDI Operations; 3.0 ProgChg In Channel; 3.1 MIDI ProgChg In Buss; 3.2 SysEx ID Number

Chapter 3 MIDI Operations
SECTION 3A MIDI, MAIN SCREEN
This screen contains four parameters, and allows access to two other MIDI functions.
MIDI SETUP
ProgChg In Chan
ProgChg In Buss
SvsEx ID Number
GLobal Transpose
1
1
000
+ 00
3.0 ProgChg In Channel
(J8 presets can be selected by like-numbered MIDI program change commands, which can be received over
their own dedicated channel and input buss. Place the cursor on the ProgChg In Chan parameter and select
a channel from 01 to 16 (or Off).
3.1 MIDI ProgChg In Buss
Selects the input buss (1 or 2) over which MIDI program change data will be received by the C8. Place the
cursor on the ProgChg In Buss parameter and select input buss 1, 2, or Off.
3.2 SysEx ID Number
In larger MIDI systems with multiple devices, it can be helpful for each device to have a unique ID number
that can be referenced by system exclusive data. To select the SysEx ID number, place the cursor on the SysEx
ID Number parameter and select a number from 000 to 127 (or Off).
3.3 Global Transpose
This allows you to transpose the notes sent by the C8 presets up or down 12 semitones. This includes notes
played on the C8 and notes received over MIDI that are merged through the Ranges. This will work in addition
to the Range Transpose values—it will not affect the key splits.
Note: MIDI notes that are received by the C8 and echoed out (but not through the Ranges) will not lx: affected
by the Global transpose. If you need them transposed, you must also set the Transpose variables on
the MIDI Merge screen.
3.4 MIDI Merge Functions
Press the Merge soft button and refer to section 3B.
3.5 MIDI Bulk Dump Functions (C8 only)
Press the BlkDump soft button and refer to section 3C.