Peavey DPM C8p - 4.5 Transmit Vol Ctrl on Recall; 4.6 Transmit Other Ctrls on Recall

4.4 E xternal Controller Type (C8 only)
When a mouse or trackball is enabled on this page, an arrow cursor appears on the display. The input device
can then be used for parameter selection and data entry (however the cursor motion, Inc/Dec, and data
sliders are still active). Peavey recommends any Microsoft® two or three button mouse (or compatibles from
Mouse Systems); the Logitech ™ C7 mouse and Trackman® trackball work well.
With a three-button mouse, clicking on l l ie left button selects the parameter to be edited. Continuing to hold
the left button down and movingthe mouse or trackball changes the parameter value. The right mouse button
is equivalent to the Exit function button.
Place the cursor on the External Controller Type parameter and choose among Disabled (no input device),
Mouse (MM) [Microsoft®], or Mouse tMSC) [Logitech ™ , etc.l.
SECTION 4B GLOBAL, PA GE #2
This screen contains five more global functions:
GLOBAL POGE #2
Transmit Uol CLrl on Recall : OH
Transmit Other Ctrls on Recoil; OH
Note Offs after HutinS : OH
Controllers after HutinS : ON
E«U4al Power Curve on Ctrls : OFF
ranaMTH MAiitji iimj-igg
4.5 Transmit Vol Ctrl on Recall
This parameter chooses whether or not any existing volume controller positions are transmitted on preset
recall. If turned ON , the controller value will be scaled with the volume on the Prg/Vol screen (section 2.10).
If turned OFF. the volume levels will go out exactly as programmed on the Prg/Vol screen. The volume
controllers) will start, working after being moved all the way up or all the way down.
4.6 Transmit Other Ctrls on Recall
1 his parameter chooses whether or not the other (non-volume) controller positions are transmitted on preset
recall. If turned ON, the controller positions will be transmitted. If turned OFF, they won’t be sent until you
move the controller.
4.7 Note Offs after Muting
When turned ON. this parameter allows Note Offs to be transmitted on a range after muting that range to
eliminate stuck notes. This only allows Note Offs for current Note Ons in that range, and only one of each.
(Once the keys are released, no more note transmissions will occur on the range.)
4.8 Controllers after Muting
When turned ON, this parameter allows controllers to be transmitted on a range after it was muted. This allows
further modulation control on still-audible notes. More importantly, it allows Sustain Off to be transmitted,
reducing the chance of stuck notes.