Peavey DPM C8p - Chapter 6: Sequence Operations; 6.0 Select Song; 6.1 Tempo; 6.2 Transmit Clocks Status

Chapter 6 Sequence Operations
The C8 can serve as a source of master timing clocks in a MIDI system, as well as send a song selection message
with each recalled preset.
Calling up a preset, then pressing the Sequence function button, presents all sequence functions on a
single screen.
Sequent.* info for :07 Pr-eset Nar»e
SonQ Select.
Tempo
Transnit Clocks
Clock OutBuss
OFF
120
PLAYONLV
6.0 SELECT SONG
This parameter determines which MIDI Song Select message will be sent upon selecting a particular preset.
Place the cursor on the Select Song parameter and using your favorite input method select a number from
1 to 127, or Off.
6.1 TEMPO
The C8 sends timing clocks at the tempo set with this parameter.
Place the cursor on the Tempo parameter and select a tempo between 40 and 250 beats per minute. A bar
next to the tempo parameter flashes at the current tempo.
6.2 TRANSMIT CLOCKS STATUS
Timing clocks can be transmitted at all times, or only when the Start button or Cont button is pressed (the
clocks then turn off if Stop is selected).
Place the cursor on the Transmit Clocks parameter and choose between Play Only (timing clock transmission
is controlled by the soft buttons) or Always (timing clocks are always being sent).
6.3 C LOCK OUTBUSS
This parameter determines the MIDI outputs over which timing clock info will be sent. Place the cursor on
the Clock OutBuss parameter and select among the following output options:
OFF 1— -2— 12— —3- 1-3- -23- 123-
—1 1—4 -2-4 12-4 —34 1-34 -234 1234