26
Operating Procedures
OPERATING PROCEDURES
Installation of the Battery
Align the indentation in the bottom of the battery with the
protrusion on the holder and insert the battery (Figure 1).
Slide the battery to the right starting from the point where it is
inserted. Push the battery until you hear it “click” (Figure 2).
If the key is inserted into the key cylinder, return it to the locking
position, remove it, and store it in a safe place.
• Note: Check to see that the battery is locked before riding
the bicycle. The battery may fall out while riding if not
properly locked in place. Before riding, make sure that the
charging port cap is closed. To prevent the battery from
falling out, do not ride the bicycle with the key inserted.
1
2
3
Figure 1 Figure 2
To Next Page
Loading...
