www.pegasustech.com.br 2
SAFETY INFORMATIONS
To ensure the safety of operators, correct installation of equipment and their preservation, the
following:
➢ Only persons trained and authorized by the manufacturer are authorized to install this
equipment, as improper intervention by an unskilled person could cause damage to the
equipment and the generator;
➢ Instruction manuals and the product identification label must always be observed before
installation,handling and parameterization;
➢ Proper precautions should be taken against falls, physical shocks and / or safety risks to
operators and equipment;
➢ Always disconnect the mains supply and wait for the machine to stop completely before
touching any electrical components associated with the equipment, this also includes the
control connectors. Do not touch the I/O connectors because high voltages may be
present even after power is disconnected and always keep them insulated from the rest
of the main generator control circuit. Check item screen printing symbology of this manual
to disconnect the equipment;
➢ Observe the warning labels affixed to the equipment, "care tension" and "warm surface
care";
➢ This equipament complies withIEC61010-1.
Always disconnect the mains supply and wait for the machine to stop
completely before touching any electrical component associated with the
equipment, this also includes the connectors of commands.
Do not open the cover of the equipment without proper precautions, as
high be present even after disconnecting the power supply.
The electronic equipment cards may have components that are sensitive
to electrostatic discharge. Do not touch components or connectors
directly. If necessary, touch the grounded metal housing or proper
grounding.
To Next Page
Loading...