How to stop foam in Pego Humidifier with high conductivity?
If your Pego Humidifier is producing foam and triggering the maximum level alarm E1 because of water conductivity above 1300 µS/cm, diminish the de-concentration discharge time by setting S2 to a lower value.
How do I fix foam production in my Pego Humidifier?
If your Pego Humidifier is producing foam, triggering the maximum level alarm E1 because of suspended particles produced by oils or greases in the inlet line, carry out several complete cylinder flushes with manual emptying immediately after complete filling.
What causes E2 alarm on my Pego Humidifier?
If your Pego Humidifier is blocked with an E2 alarm, verify the condition of the humidity duct sensor. This is due to a functional fault of the humidity duct sensor.
Why is my Pego Humidifier blocked with En alarm?
If your Pego Humidifier is blocked with an En alarm, verify the right connection between the SLIM controller and TLD electronic. This is due to a lack of connection between them.
What does E0 alarm mean on Pego Humidifier?
If your Pego Humidifier is blocked with an E0 alarm, verify the condition of the humidity sensor. This is due to a functional fault of the humidity sensor.
Why Pego Humidifier alternately displays OFF and normal visualization?
If your Pego Humidifier is on but alternately displays OFF and normal visualization and it doesn’t fill water, verify enabling on terminal blocks 1 and 2 on the 100 Master card, because there might be a missing enabling signal.
General| Brand | Pego |
|---|---|
| Model | ES3-M |
| Category | Humidifier |
| Language | English |
To Next Page
