pellenc FIXION 2 - 5.4. RELOAD THE SMALL TIE BAND SPOOL

TYING MACHINE FIXION 2
29_133084-G
5.4. RELOAD THE SMALL TIE BAND SPOOL
1. Block the rear flange and turn the front flange clock-
wise to unlock it.
2. Remove the front flange from the adaptable dis-
penser (6).
3. Place the tie band spool on the hub of the adaptable
dispenser (6).
4. Ensure the correct direction of exit of the ties end.
Note
The tie band spool must unwind clockwise.
5. Replace the front flange on the hub of the adaptable
dispenser (6).
6. Block the rear flange and turn the front flange an-
ti-clockwise to lock it.
18