Penlon Prima 451 - Electromagnetic Compatibilty (EMC)

35 Prima 451 – User Manual
Appendix
Appendix 4. Electromagnetic compatibility (EMC)
Electromagnetc envronment
Ths devce s sutable for use n the specfed electromagnetc envronment The user should assure that t s used n an
electromagnetc envronment as descrbed below
hanges or modfcatons to ths devce, not expressly approved by Penlon Lmted, could result n EM ssues wth ths devce
ontact Penlon Lmted for more nformaton
The use of phones or RF emttng equpment near ths anaesthetc machne may cause nterference
Always montor anaesthetc machne operaton before and durng use on a patent
The essental performance of the Prma 451 anaesthetc machne s to provde controlled concentratons and flows of
anaesthesa gases nto a patent breathng system
WARNIN
The devce should not be used adacent to other manufacturer’s equpment If adacent use s necessary, the devce should
be observed to verfy normal operaton n the confguraton n whch t wll be used
ables, Transducers, and Accessores
WARNIN
The devce s EM-complant wth all cables, transducers and accessores suppled by Penlon Lmted
The use of cables, transducers and accessores other than those specfed may result n ncreased emssons or decreased
mmunty of ths devce
The use of cables, transducers and accessores suppled by Penlon Lmted on non-Penlon equpment may also result n
ncreased emssons or decreased mmunty of that equpment
Cables supplied by Penlon Limited
Category
Function Length (m)
A mans supply nput/output ports Hospital mains supply to the input port (cable is
fixed to the Prima 451.
≤3.9
A lnk Prma 451 equpped wth an AV-S MRI vent-
lator
Connects the Master on/off control on the
Prima 451 to the AV-S MRI ventilator
0.4
A200SP control cable (Prma 451 equpped wth an
AV-S MRI ventlator)
Connects (a) the spirometry sensors, and (b)
the absorber bag/vent switch on the A200SP
MRI absorber to the AV-S MRI ventilator
0.8
Oxygen sensor cable (Prma 451 equpped wth an
AV-S MRI ventlator)
Connects the oxygen sensor on the A200SP
MRI absorber to the AV-S MRI ventilator
2.7
Guidance and manufacturer’s declaration – electromagnetic emissions
Ths devce s ntended for use n the electromagnetc envronment specfed below The customer or user should assure that t
s used n such an envronment
Required test Compliance omments
RF emssons
ISPR 11
Group 1
Class A
lass A equpment s sutable for use n all locatons other than those
allocated n resdental envronments and those drectly connected
to a low voltage power supply network whch supples buldngs used
for domestc purposes, and may be used n domestc establshments
and those drectly connected to the publc low-voltage power supply
network that supples buldngs used for domestc purposes provded the
followng warnng s heeded
NOTE The EMISSIONS characterstcs of ths equpment make t
sutable for use n ndustral areas and hosptals (ISPR 11 class A) If
t s used n a resdental envronment (for whch ISPR 11 class B s
normally requred) ths equpment mght not offer adequate protecton
to rado-frequency communcaton servces The user mght need to take
mtgaton measures, such as relocatng or re-orentng the equpment
Harmonc emssons
IE 61000-3-2
Complies
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies