10
CLEAN AND CLEAR
®
PLUS Cartridge Filter Installation and User’s Guide
Replacing Filter Cartridges
Filter cartridge element life will vary with pool conditions such as bather load, wind, dust, etc. You can expect an
average cartridge life of three years under normal conditions.
TO REPLACE FILTER CARTRIDGES:
1. Follow Opening the Filter on page 4 exactly.
2. Remove the Compression Spring and Spring Adapter from the Top Manifold.
3. Remove the top manifold from the lter cartridges and lay the manifold aside. See FIGURE 8 on page 8.
4. Carefully remove each cartridge separately.
5. Inspect the gasket around outer lip of bottom plate. The gasket must be rmly and evenly seated around the
entirety of the outer lip.
6. Install the replacement cartridges onto the bottom manifold. Reinstall the top manifold on to the new cartridges.
Note: Be sure the spring and standpipe assembly are retained on the top manifold.
7. Follow Installing the Filter Lid and Clamp Ring on page 5 exactly.
To Next Page
Loading...
Need help?
General
