Pentair Fleck 5800 LXT - Troubleshooting Lxt

15 - TROUBLESHOOTING LXT
Error Codes
NOTE: Error codes appear on the In Service display.
Error Code Error Type Cause Reset and Recovery
---0 Motor Stall /Cam
Sense Error
No state changes in the optical
sensor are detected for 6 seconds.
Unplug the unit an plug back in. Allow the control to attempt to nd
position again.
Verify the optical sensor is in place with the wires connected to the
circuit board. Verify the motor and drive train components are in good
condition and assembled properly. Check the valve and verify that the
piston travels freely. Replace/reassemble the various components as
necessary.
Plug the unit back in and observe its behavior. If the error reoccurs,
unplug the unit, put it into bypass and contact technical support.
---1 Motor Run-On
Error /Cycle
Sense Error
An undesired optical sensor state
change occured.
Non-critical error. Extra optical sensor pulse detected. Press any button
to clear the error. Press extra cycle button to advance motor to clear
error.
---2 Regen Failure The system has not regenerated in
30 days.
Perform a Manual Regeneration to reset the error code.
If the system is metered, verify that it is measuring ow by running
service water and watching for the ow indicator on the display. If the
unit does not measure ow, verify that the meter cable is connected
properly and that the meter is functioning properly.
Enter Master Programming Mode and verify that the unit is congured
as appropriate for the valve conguration. Check that the correct system
capacity and meter size has been selected.
---4 Fail Safe Error Valve has failed to nd position in
one minute.
Unplug the unit and plug it back in. If error continues, call technical
support.
18 • MR12 Fleck 5800 LXT & SXT Downow/Upow