Pentair Fleck 5800 LXT - User Programming Mode Sxt

13 - USER PROGRAMMING MODE SXT
Abbreviation Parameter Description
DO Day Override The timer's day override
setting.
RT Regeneration Time The time of the day that
the system will regenerate
(meter delayed, timeclock,
and day-of-week systems)
H Feed Water
Hardness
The hardness of the inlet
water - used to calculate
system capacity for
metered systems.
RC or SF Reserve Capacity The xed reserve capacity.
CD Current Day The current day of week.
NOTE: Some items may not be shown depending on timer
conguration. The timer will discard any changes
and exit User Programming Mode if a button is not
pressed for 60 seconds.
User Programming Mode Steps
1. Press the Up and Down buttons for ve seconds while in
service, and the time of day is NOT set to 12:01 PM.
2. Use this display to adjust the Day Override. This option
setting is identied by "DO" in the upper left hand corner of
the screen.
Figure 29
3. Press the Extra Cycle button. Use this display to adjust the
Regeneration Time. This option setting is identied by "RT"
in the upper left hand corner of the screen.
Figure 30
4. Press the Extra Cycle button. Use this display to adjust the
Feed Water Hardness. This option setting is identied by
"H" in the upper left hand corner of the screen.
Figure 31
Range: 1-199 hardness
5. Press the Extra Cycle button. Use this display to adjust the
Fixed Reserve Capacity. This option setting is identied by
"RC" or "SF" in the upper left-hand corner of the screen.
Figure 32
6. Press the Extra Cycle button. Use this display to set the
Current Day of the Week. This option setting is identied by
"CD" in the upper left hand corner of the screen.
Figure 33
7. Press the Extra Cycle button to end User Programming
Mode.
16 • MR12 Fleck 5800 LXT & SXT Downow/Upow