Pentair FLECK 5800 - WIRING DIAGRAM; XTR2 Control Wiring; IOT Module Wiring

WIRING DIAGRAM
COMM PORT
12VDC
--
+
TOUCHSCREEN
RESET
SWITCH
USB
CHLORINE
GENERATOR
44459 REV B
AUX1 CMN
AUX1 NO
AUX1 NC
PRODUCTION
TEST PORT
--
+
24VDC
FLOW METER
MOTOR / OPTO. ENC.
REMOTE REGEN LOCK
REMOTE REGEN START
GND
AUX2 CMN
AUX2 NO
AUX2 NC
NOTE: The reset switch discharges the super capacitor when power is removed
from the control. The super capacitor retains the current time of day in
the event of a power failure. Pressing the reset switch on the circuit board
while power is applied to the control will have no effect on the control or
stored settings.
Chlorine Generator can only be used with +12VDC power supply
(international version only).
+12VDC power supply with 5800, 5810, 5812 valves only.
44459 Rev B
44452U Rev C
12VDC
12VDC
+
--
COMM PORT
--
+
44452U REV C
XTR2
IOT
FLECK 5800/5810/5812 XTRI Service Manual • 43