Pentair KEYSTONE EPI-2 - 4.9 Terminal Board Enclosure Removal; 4.10 Cables Connections; Cable Connection Safety and Precautions

11
FIGURE 8 - Removal of the terminal board enclosure.
WARNING
Pay attention not to damage the joint surfaces of
the cover.
WARNING
Do not remove earth connection X while
connecting the actuator to plant earthing.
IMPORTANT
All the accessories which equip the EPI-2, in
particular the cable glands, must be certified
according to the Standard Directive and specific
Rules applying to the products.
FIGURE 9 - Overview of the electrical connections.
Earth connection X
4.9 REMOVAL OF THE TERMINAL BOARD ENCLOSURE
Using a 5 mm Allen key, loosen the four screws and remove the cover.
4.10 CABLES CONNECTIONS
Before applying voltage to the EPI-2 check that the electrical parameters (supply voltage
and current) shown on the nameplate and on the attached wiring diagram are correct for the
installation.
KEYSTONE EPI-2 QUARTER-TURN ELECTRIC ACTUATOR
InstallatIon and MaIntenance InstructIons