Pentair KEYSTONE EPI-2 - EPI-2 Model 500 - General Assembly

25
EPI-2 MODEL 500 - GENERAL ASSEMBLY
Pos. Description Quant.
1 Nut UNI 5588-M12 2
2 Nut UNI 5588-M6 2
3 Eccentric 1
4 Planocentric gear 2
5 Spacer 1
6 Ball bearing type 6005 2
7 Ball bearing type 6202 1
8 Ball bearing type 16002 1
9 ESH screw UNI 5931-M6x8 1
10 HSHC screw UNI 5931-M6x16 4
11 HSHC screw UNI 5931-M10x25 4
12 HSHC screw UNI 5931-M4x14 7
13 HSHC screw UNI 5931-M6x20 2
14 HSHC screw UNI 5931-M6x25 4
15 HSSC screw UNI 5933-M4x10 1
16 HSSC screw UNI 5933-M5x12 3
17 Cover assembly 1
18 Drive and control assembly 1
19 Handwheel 1
20 Housing 1
21 Motor pinion 1
22 Output drive assembly 1
23 Stopper 2
24 Terminal block 1
25 Anti-loosening washer UNI 8842-J6 2
26 Base plate ISO 5211 F10-F12 1
27 Cover gasket 1*
28 Dowel pin UNI EN 22338 1
29 Earth stud 1
30 Fixed anulus 1
31 Gasket 1*
32 Indicator 1
33 Indicator shaft 1
34 Manual worm shaft 1
35 O-ring Di=10.77/W=2.62 1*
36 O-ring Di=18.77/W=1.78 1*
37 O-ring Di=6.07/W=1.78 1*
38 O-ring Di=69.52/W=2.62 1*
39 Plug 1
40 Position label 1
41 Power clamps protection 1
42 Ring 1
43 Ring for pins alignement 1
44 Ring RW 10 UNI 7433 2
45 Seal washer 12.3 2
46 Sliding ring 1
47 Snap ring for shaft D.12 1
48 Terminal block cover 1
49 Terminal board gasket 1*
50 Wheel 1
51 Worm shaft flange 1
KEYSTONE EPI-2 QUARTER-TURN ELECTRIC ACTUATOR
InstallatIon and MaIntenance InstructIons
* Indicates recommended spare parts