Pentair STA-RITE - Installation; Motor;Pump Lifting Procedure

Installation 4
Motor/Pump Lifting Procedure
Heavy parts.NEVERwalkorreachundera
suspendedpump.DONOTscrewaneyeboltintothe
motor housing and attempt to lift assembly!
The crane or hoist must have a capacity in excess of
the combined weight of the motor and pump. Use a
minimum of two chains or straps to lift motor/pump
assembly,asshownbelow.Eachchainorstrapmusthave
a capacity in excess of the combined weight of the motor
and pump.
Wrap the first chain or strap under the fan end of the
motor up tight against the motor feet, and the second
chain or strap under the pump bracket between the
pump end and the motor.
Raisemotor/pumpassemblyslowlytoensurethatthe
chains or straps will not slip when put under tension.
Balancemotorandpumpwithchainsorstrapsto
maintain proper weight distribution. If not balanced,
release tension on the chains or straps and readjust.
6545 0412