Pentair WATER SOFTENING SYSTEM 1.0 - Page 17

WHOLE HOUSE WATER SOFTENING SYSTEM • 17
ADVANCED MENU CONTINUED
4. DAYS OVERRIDE
The control will display:
• Press the UP or DOWN ARROW to set the number of days between regenerations. The setting range
is OFF to 30 days.
In most situations with a meter equipped valve, override can remain “OFF”. Set a number if days if you
wish to have the system regenerated periodically regardless of water use.
Press the SCROLL BUTTON to advance to the next setting.
5. CYCLE 1 - BACKWASH
The control will display:
• Press the UP or DOWN ARROW to change the length of the backwash cycle. The setting range is 5 to
99 minutes. We do not recommend a backwash of less than 10 minutes.
Press the SCROLL BUTTON to advance to the next setting.
6. CYCLE 2 - BRINE/SLOW RINSE
The control will display:
Press the Up or Down ARROW to change the length of the brine/slow rinse cycle. The minimum length is
preselected based on unit size and salt level, and cannot be reduced. The maximum setting is 99 minutes.
Press Down Arrow to exit Installer’s Mode.
IMPORTANT NOTE: TO ACTIVATE THE NEW SETTINGS, YOU MUST EXECUTE A COMPLETE REGENERATION.
IF YOU DO NOT MANUALLY REGENERATE THE SYSTEM, THE SETTINGS WILL NOT BECOME ACTIVE UNTIL
THE UNIT HAS COMPLETED THE NEXT SCHEDULED REGENERATION.
Backwash: 10 min
BRN/RNS: 74 min
To Exit Press Down Arrow
Override: OFF
Notice
Notice