29
Preparation and inspection
3
█
Inspection of the right / left bending lock mechanism
1. Turn the right / left angulation lock knob counterclockwise until it stops.
Figure 3.16
2. Turn the right / left angulation control knob slowly in the “
▲
R” or “
▲
L” direction until it stops.
Figure 3.17
3. Check that the curved form of the bending section is fixed when releasing the angulation control
knob.
4. Turn the right / left angulation lock knob in the “F
►
” direction until it stops to release the lock.
Check that the bending section returns to a straight orientation.
Figure 3.18
To Next Page
Loading...
