105
Shooting Functions
4
1
Select S in Step 3 on p.104, and press the 4 button.
2
Press the 3 button or the shutter release button
halfway.
The camera returns to the status screen and is ready to take a picture.
3
Select the desired AF point.
Available operations
Selecting the Desired Focusing Point
Four-way controller (2345) Changes the AF point.
4 button Returns the AF point to the center.
Press and hold 4 button Disables changing the AF point and
enables direct key operation of the four-
way controller.
To enable changing the AF point, press
the 4 button again while direct key
operation is enabled.
• The position of the changed AF point is stored even if the focus point
selection mode is switched to b, c or O, or the camera is turned off.
•
If [AF Active Area] is assigned to the
V
/
Y
button in [Button
Customization] of the [
A
Rec. Mode 4] menu (p.167), press the
V
/
Y
button to enable or disable changing the AF point, and turn the front/rear e-
dial to change the AF point as in Step 4. You can select the upper or lower AF
point with the front e-dial (
R
), and the left or right with the rear e-dial (
S
).
Press the
d
button to return the AF point to the center of the AF frame. This
is useful when operating the camera while looking through the viewfinder.
• When [Expanded Area AF] in [AF Settings] of the [A Rec. Mode 2] menu is
enabled, if your subject briefly moves out from the focus point that was
selected when the focus mode was set to k (or when [AF.A] was
enabled), the camera will continue to focus on your subject based on
information from the focus points (back-up focus points) surrounding the
selected focus point. The back-up focus points are displayed in pink on the
status screen.
• You will hear a beep when switching between enabling or disabling changing
the AF point. The beep can be turned off. (p.208)
To Next Page
Loading...
