250
Using the Flash
9
1
Set the wireless mode of the external flash directly
connected to the camera to [MASTER] or [CONTROL].
2
On the wireless remote flash unit, set the wireless flash
mode to [SLAVE] and set the channel to the same channel
as the flash directly connected to the camera. Then, place
it at the desired location.
3
Confirm that both flashes are fully charged, and then take
a picture.
When using an external flash away from the camera, attach the Hot Shoe
Adapter FG (1; optional) to the camera hot shoe and an Off-Camera Shoe
Adapter F (2; optional) to the bottom of the external flash, and then
connect these with the Extension Cord F5P (3; optional). The Off-
Camera Shoe Adapter F can be mounted to your tripod using the tripod
screw.
Wireless Shooting Using a Combination of External
Flash Units
MASTER
Discharge both the flash directly connected to the
camera and the wireless flash unit as the main flash.
CONTROL
Discharges the flash directly connected to the camera as
a control flash only, not as the main flash.
• The Shake Reduction function is not available.
• When using multiple AF540FGZ/AF360FGZ external flashes and shooting
with the high-speed sync flash in wireless mode, set the flash directly
connected to the camera to high-speed sync flash mode.
Connecting an External Flash with an
Extension Cord
To Next Page
Loading...
