249
Using the Flash
9
Set the camera to wireless flash mode when using an external flash in
combination with the built-in flash.
1
Remove the external flash unit after the channel is set on
the camera, and place it at the desired location.
2
Set the camera’s flash mode to
r.
The camera is ready to take a picture.
The channel for the built-in flash is
displayed in the viewfinder.
3
Press the E button.
4
Confirm that both flashes are fully charged, and then take
a picture.
Wireless Shooting Using a Combination of the Built-in
Flash and an External Flash Unit
r is not available in the following situations.
•In C mode
• when the drive mode is set to [Remote Control (3 sec. delay)]
• when the lens aperture ring is set to a position other than s
You can change the built-in flash discharge method used in wireless mode. Set
in [17. Flash in Wireless Mode] of the [A Custom Setting 3] menu.
CancelCancel
MENU
Wireless ModeWireless Mode
OKOK
OK
0.00.0
On
Discharges the built-in flash as a master flash. (default
setting)
Off Discharges the built-in flash as a control flash.
To Next Page
Loading...
