Pentax K-50 - Page 211

209
Changing Additional Settings
7
The date and time set in “Initial Setting” (p.58) serve as the date and time
of your present location. Setting the destination in [World Time] enables
you to display the local date and time on the monitor when traveling
abroad.
1 Select [World Time] in the [R Set-up 1] menu, and press
the four-way controller (5).
The [World Time] screen appears.
2 Use the four-way controller (45)
to select X (Destination) or W
(Hometown) for [Time Setting].
This setting is reflected in the date and
time that appear in the control panel.
3 Press the four-way controller (
3
) to select [
X
Destination],
and press the four-way controller (
5 ).
The [X Destination] screen appears.
4 Use the four-way controller (45)
to select a destination city.
Turn the rear e-dial (S) to change the
region.
The location, time difference and current
time of the selected city appear.
5 Press the four-way controller (3) to select [DST], and use
the four-way controller (45) to select P or O.
Select O if the destination city uses daylight saving time (DST).
6 Press the 4 button.
The destination setting is saved and the screen that was displayed in
Step 2 appears again.
Setting the World Time
MENU
World TimeWorld Time
Time SettingTime Setting
DestinationDestination
LondonLondon
HometownHometown
New YorkNew York
16:0016:00
10:0010:00
DestinationDestination
DSTDST
LondonLondon
CancelCancel
MENU
OKOK
OK
+06:00 +06:00
16:0016:00