121
Shooting Functions
4
5
Press the four-way controller (3)
and use the four-way controller
(45) to select hor i.
The self-timer lamp will blink to let you
know that the camera is in remote control
wait status.
6
Press the 4 button.
The camera is ready to take a picture.
7
Press the shutter release button halfway.
The autofocus system operates. The focus indicator ] appears in the
viewfinder when focused.
8
Point the remote control unit
towards the remote control
receiver on the front of the
camera and press the shutter
release button on the remote
control.
The operating distance of the remote
control unit is about 5 m from the front of the camera.
For h, the shutter will be released immediately after the shutter release
button is pressed.
For i, the shutter will be released in three seconds after the shutter
release button is pressed.
After the picture is taken, the self-timer lamp lights for 2 seconds and
then returns to blinking.
• You cannot focus with the remote control unit in default settings. Focus on
the subject first with the camera before operating with the remote control.
You can set [9. AF in remote control] to [On] in the [A Custom Setting] menu
(p.75).
• When using the remote control unit, flash does not pop up automatically even
when set to g (Auto discharge). Pop up the flash manually beforehand.
(p.65)
OK
OK
OK
Drive Mode
Remote Control Unit
R e mo t e C o n t r o l U n i t
Drive Mode
Remote Control Unit
5 m
To Next Page
Loading...
Need help?
General
Weight and Dimensions
