Pentax SF10 - Focusing

7. FOCUSING
1 . Position the subject in the auto-focus frame in the
viewfinder and lightly press the shutter release button.
2. When the subject is captured in focus, a green in-focus
signal f O 1 comes on in the viewfinder and a PCV
tone confirms it audibly.
^ If the in-focus signal ( O ] blinks, the subject is too
close or is difficult to focus on (see page 42).
Note:
• The shutter can be released only when the subject is
in focus.
• Once the subject is captured in focus, focusing is
locked. In order to take a different subject, remove
the finger from the shutter release button, then press it
down again.
• 18