09931228D
PerkinElmer, 710 Bridgeport Avenue,
Shelton, CT 06484-4794, U.S.A
Produced in the USA.
Lambda 265 Peltier Controlled Single Cell,
With Peltier Controller Installation Instructions
This instruction sheet describes the installation of this accessory which is used with the Lambda 265
Spectrophotometer.
NOTE:
Read these instructions before you install this accessory.
Supplies, replacement parts, and accessories can be ordered directly from PerkinElmer, using the part
numbers.
See our website:
http://perkinelmer.com
PerkinElmer's catalog service offers a full selection of high-quality supplies.
To place an order for supplies and many replacement parts, request a free catalog, or ask for information:
If you are located within the U.S., call toll free 1-800-762-4000, 8 a.m. to 8 p.m. EST. Your order will be
shipped promptly, usually within 24 hours.
If you are located outside of the U.S., call your local PerkinElmer sales or service office.
• Easy to install
• Full software control
• Liquid cooling system
• N2 gas available
Figure 1. Lambda 265 Peltier control Single Cell [P/N: N4103005] and peltier
temperature controller [P/N: 4100040]
To Next Page
Need help?
General
