09931228D
Block: The temperature of Cell Block
Probe 1: The temperature of Probe 1
Probe 2: The temaperature of Probe 2
Example: If Block is selected, measurement will start when the temperature of the cell block
reaches the setting temperature.
▶Temperature Display
Select which temperature will be displayed on the panel: Block, Probe 1 or Probe 2. The selected
temperature is only displayed in real time.
▶Option: This function is used to adjust temperature. Itis only used for the manufacturing
process, so do not modify the values.
8. After completing the parameter setup, select OK. Then the LED of the On-LINE light on the
Peltier controller will be turned on. It will start heating up or cooling down to the set temperature
in the Setup Single Cell Peltier.
9. Select Blank, and then the blank is measured when it reaches the set Start Temperature.
NOTE:
To monitor the probe temperature, the probes should be immersed in the sample, or to use the block
temperature for monitoring, the cell lid should be closed tightly.
10. Select Sample.
11. When the temperature reaches the target temperature, the measurement starts.
To Next Page
Loading...
Need help?
General
