30. Lambda 265, 365 and 465 ASX-260 AND ASX-520 Autosampler Users Guide
3. Press the cassette down to lock the right side snap lever on the locking bar.
4. Connect to the flangeless fittings to the inlet and outlet tubes for the flow cell.
5. Connect one connector of the inlet tube to the port of the flow cell with the arrow
mark and the other connector of the inlet tube to the upper port inside of the
front plate for Auto Sipper Accessory, and connect the outlet tube to the outlet
port of the flow cell and to the lower port inside of the front plate for Auto Sipper
accessory.
To Next Page
Loading...
Need help?
General
