Language - only ENGLISH is available.
Audible alerts - select ON if you want the instrument to beep
when incubation is completed. Select OFF if you do not want it to
beep.
Show temp - there are three options (see below)
Incub - the temperature in the incubation chambers
(displayed with a 0.1°C accuracy). This will be shown
at the bottom of the operational display. The incubation
temperature needs to be selected to enable the following of
the temperature during the incubation cycle.
Ambient - this is for service purposes. The temperature in the
electronics compartment will be shown at the bottom of the
operational display.
OFF - no additional temperature will be shown at the bottom
of the operational display. Not recommended.
Press the Start/Pause button to save these values and go to the
Program selection mode.
Note: Do not use this function at the same time as editing the other Setup parameters because when you switch off the
instrument, changes made to them will be lost.
TriNEST Microplate incubator and shaker
Operating instructions
17