4
User’s Handbook, TSL 4230, Issue 4 23
4016-E61TRS
D service - 8,000 and 24,000 hours
E service - 10,000, 14,000, 26,000 and 30,000 hours
Description Manual
Check EMS logged events and record
DM
Check EMS logged diagnostic codes, record and rectify
Clean the filter gauze for the piston cooling jet oil gallery UH
Equalise bridge pieces and set valve clearances UH
Check valve and seat recession UH
Check and clean spark plugs, reset gap UH
Breather element - renew UH
Air filter - renew (subject to environmental conditions) UH
Charge cooler - clean and fit new gasket WM
Test sensors and protection systems annually DM
Check coolant anti-freeze/inhibitor strength annually UH
Calibrate oxygen sensor, renew if necessary UH - DM
Calibrate turbine inlet temperature interface module DM
Check emissions (adjust if required) DM
Magnetic pick-ups - clean and adjust WM
Check and calibrate ignition timing DM
Description Manual
Check EMS logged events and record
DM
Check EMS logged diagnostic codes, record and rectify
Equalise bridge pieces and set valve clearances UH
Check valve and seat recession UH
Check and clean spark plugs, reset gap UH
Breather element - renew UH
Air filter - renew (subject to environmental conditions) UH
Calibrate oxygen sensor, renew if necessary UH - DM
This document has been printed from SPI². Not for Resale
To Next Page
Loading...
