Owner´s Manual Permobil C500 Handling
57
Charging
1. Loosen the charging sockets round rubber protection and connect the
charger plug into the battery charging socket up on the right side at the
rear end of the chassis cover.
2. Connect the charger to the 110 volt supply and turn on the power for the
charger.
Description and Use of Battery Charger, see supplied Owner’s Manual.
Only use the battery charger that has been supplied with your wheelchair or recommended by
Permobil. The use of incorrect chargers could damage the batteries, wheelchair, control system or
charger itselt, or may result in parts overheating creating the potential for burns or even fire.
To avoid sparking and unnecessary wear and tear of the wheelchair’s charging socket, be sure that
the main voltage and the charger is in OFF position when connecting/disconnecting the charging
cable to the wheelchair’s charging socket.
Charger Connection
Ensure that the charger plug is pushed fully in position.
You will not be able to drive the wheelchair when the charger is connected. If the wheelchair does
drive with the charger plugged in, contact your Permobil serviceman as soon as possible.
NOTE
WARNING
To Next Page
Loading...
