Owner´s Manual Permobil C500 R-net Diagnostics
92
4.5 Lights, Indicators and Hazard Lamps Test
If lights are fitted:
• Visually check each bulb for correct illumination.
• Check each bulb for correct illumination and that the flashrate is
1.5Hz ± 0.5Hz.
• Disconnect each bulb in turn and check that the remaining bulb for that
side flashes at 3Hz ± 0.5Hz.
If hazard lamps are fitted:
• check each bulb for correct illumination and that the flashrate is
1.5Hz ± 0.5Hz.
4.6 Actuator Test
If actuators are fitted:
• Check each motor for correct direction of movement.
• Ensure the mechanical end-stops are secure and that they stall the actu-
ator motors, thus operating the ISM’s automatic end-stop detection.
4.7 Inhibit Input Test
Insert an appropriate battery charger, or equivalent inhibit connection, into the
Charger Connector on the JSM and ensure that drive is inhibited.
If Inhibits 2, 3, 4 and 5 are used for inhibit or speed limiting purposes, suitable
tests should be devised to ensure correct operation.
To Next Page
Loading...
