11
Changing the batteries
Battery connections
+
+
–
–
Green cable - Batt. +
Red cable - Batt. +
Front
Black cable - Batt. -
Green cable - Batt. -
Fitting
1. Insert two new gel batteries. The battery poles must face out from the centre.
2. Fix the batteries in place with the straps.
Tighten the straps properly so that the clamping bow is tensioned.
3. Connect the battery connections, first the negative poles and then the positive poles.
NB. The cables must be located correctly. See the figure below.
4. Refit the cover after the rear lighting cable has been connected to the jack panel. See page 7.
5. Switch on the battery cut-out.
6. Charge the batteries.
Front
Clamping
bow
To Next Page
Loading...
