25
Changing the seat lift motor
Removal
1. Raise the seat lift and remove the cover.
See page 7.
2. Disconnect the seat lift motor's cables
from the jack panel.
3. Unscrew the two screws which hold the
motor at the very rear of the seat lift.
See the figure to the right. Pull the motor
backwards so that the motor is released.
Changing the seat lift motor
Seat lift motor mounting
Seat lift motor connection
The seat lift motor must not be operated before
the motor has been properly screwed to the
seat lift. See the figure at the top right.
There is a risk of material damage.
Fitting
1. Press the motor shaft into the seat lift's
screws.
2. Tighten the two screws which fix the motor
in place on the rear of the seat lift.
See the figure to the right.
3. Connect the seat lift motor's cables to the
jack panel.
Warning!
Cable connection
Cable connection
Motor mounting
WARNING!
To Next Page
Loading...
