13
Changing the front wheel
Release the axle nut
Thread off the axle nut
Removing the front wheel
1. Raise and block up the wheelchair's chassis
so that the wheel does not reach the ground.
Remove the plastic plug from the centre hole.
2. Fold out the locking lip on the toothed plate
connector.
3. Thread the axle nut off the wheel axle.
4. Pull the wheel off the axle.
Fitting the front wheel
1. Fit the wheel onto the axle.
2. Place the locking washer on the axle.
3. The nut must not be tightened too hard.
The wheel must turn easily. Fold the toothed
plate connector's locking lip into the axle nut's
recess so that it is fixed.
4. Thread the plastic plug back into the centre of
the wheel rim.
To Next Page
Loading...
