Changing the brake release wires
14
Brake release mechanism
Changing the brake release wires The right wire controls the left brake unit and the left
wire controls the right brake unit.
Removal
1. Raise the seat lift to its highest position. If the chair is equipped with a fixed seat tube, the screw
at the rear of the seat must be loosened so that the seat can be tipped forwards.
2. Remove the cover. See page 7. Press the brake release handle down to its lower position to
facilitate removal.
3. Loosen the two screws in the pinch protection plate (1).
4. Loosen the locking nut (2).
5. Screw the adjusting screw (3) all the way in.
6. Loosen the wire at the magnetic brake and at the brake release handle.
2 3
1
Magnetic brake
Release clamp
To Next Page
Loading...
