Mounting and commissioning the machine
8 - 4
8.02 Commissioning the machine
● Check the machine, especially the electrical leads, for any damage.
● Clean the machine thoroughly (see chapter 10 Care and maintenance).
● Have specialists ensure that the machine’s motor can be operated with the available
electricity supply and that it is connected properly. If not, the machine must not be
operated.
8.03 Turning the machine on/off
● Turn the machine on/off by pressing the
switch 1.
● LED 2 is for monitoring the machine
controller.
Switch 1 on:
LED ON = controller
operative
LED blinking = malfunction
Switch 1 off:
LED blinking = controller will
remain live for
approx. 4 seconds
LED off = controller off
Refer to the instruction manual of the motor for a description of additional
functions.
Fig. 8 - 06
1
2
To Next Page
Loading...
