8 - 4
Installation and commissioning
8.02 Commissioning
● Examine the machine, in particular the electric cables, for any damage.
● Before commissioning the machine, clean it thoroughly and then oil it, see
Chapter 10 Care and Maintenance!
The machine may only be connected to an earthed socket!
Have qualified personnel check whether the machine’s motor can be operated
with the available voltage and whether it is connected properly. If there are any
irregularities do not operate the machine!
● When the machine is running, the balance wheel must turn towards the operator. If this
is not the case, have the motor adjusted by qualified personnel, see the Motor Instruction
Manual.
8.03 Switching the machine on/off
● Switch on the machine, see Chapter 7.01 Main switch.
● Carry out a test run.
To Next Page
Loading...
