9 - 1
Preparation
110-015
9 Preparation
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained personnel.
Before all preparation work, the machine is to be separated from the electricity
supply by removing the plug from the mains or switching off the On/Off switch!
9.01 Inserting the needle
Switch off the machine!
Danger of injury due to
unintentional starting of the
machine!
Only use needles from the
system intended for the
machine, see Chapter 3
Specifications.
● Raise the needle bar to its top position
and loosen screw 1.
● Insert the needle as far as possible and
align it so that the long needle groove is
facing forwards.
● Tighten screw 1.
Fig. 9 - 01
1
To Next Page
Loading...
Need help?
General
