10 - 1
Care and maintenance
110-022
10 Care and maintenance
10.01 Maintenance intervals
Cleaning .............................................................. daily, several times if in continuous use
Oiling the hook .................................................... daily, several times if in continuous use
Oiling the machine ........................................................................................ once a week
During all cleaning work the machine must be disconnected from the power
supply by switching off the main switch or pulling out the plug!
Danger of injury if the machine is started accidentally!
10.02 Cleaning the machine
The cleaning cycle required for the machine depends on following factors:
● Single or several shift operation
● Amount of dust resulting from the workpiece
It is therefore only possible to stipulate the best possible cleaning instructions for each indi-
vidual case.
For all cleaning work the machine must be disconnected from the mains by
switching off the on/off switch or by removing the mains plug!
Danger of injury if the machine suddenly starts up .
● Tilt back the machine.
● Clean the hook and hook compartment
daily, more often if in continuous
operation.
Return the machine to its upright
position using both hands!
Danger of injury by crushing
between the edge of the
machine and the table top!
Fig. 10 - 01
To Next Page
Loading...
