Need help?Do you have a question about the Pfaff 3114 and is the answer not in the manual?
General| Brand | Pfaff |
|---|---|
| Model | 3114 |
| Category | Sewing Machine |
| Language | English |
Step-by-step procedure for correctly inserting the needle into the machine.
Detailed instructions on how to thread the needle using various guides and levers.
Explains the process of winding thread onto the bobbin using the bobbin winder.
How to remove and replace the bobbin case from the sewing machine hook.
Instructions on how to thread the bobbin case, ensuring correct thread path.
How to adjust the bobbin thread tension for optimal stitch formation.
Guide to adjusting the two needle thread tensions for proper stitch balance.
Correctly positioning the fabric under the needle and work clamp.
How to safely start the sewing machine and familiarize oneself with its operation.
Procedures for stopping the machine after completing a buttonhole or during operation.
Emergency procedures for stopping the machine quickly to prevent damage.
Adjusting the machine to set the desired length of the buttonhole.
How to change gears to alter the number of stitches for buttonhole density.
Adjusting stitch width for bartacks and buttonhole parallels.
Setting the buttonhole's position relative to the cutting mechanism.
Fine-tuning the spacing of the parallel stitches in a buttonhole.
Procedure for replacing the buttonhole cutting knife.
Ensuring the knife holder is set correctly for accurate cutting.
Operation and adjustment of the automatic needle thread trimming mechanism.
Operation and adjustment of the automatic bobbin thread trimming mechanism.
Sequence for managing needle thread before cutting.
Explanation of how the buttonhole cutting knife operates.
Steps for removing the hook for cleaning or maintenance.
Adjusting the hook timing for correct loop formation and stitch creation.
Setting the work clamp pressure for different fabric types.
Procedure for replacing the buffer spring in the machine's drive system.
Adjusting the lever that controls the machine's stopping mechanism.
Fine-tuning the brake lever for proper machine stopping.
Adjusting the lever that initiates the stopping sequence.
Adjusting the manual stop lever for machine control.
Adjusting the segment that triggers the machine's stop function.
Adjusting segments that control bartacking timing.
Adjusting the zero lug for precise needle positioning.
Adjusting the brake on the feed cam to prevent reverse movement.
Setting the point at which the tension release mechanism is activated.
Adjusting the lever that controls the machine's start sequence.
To Next Page
