Photo
19
Although it is possible to resume sewing at the point the thread has broken,
or a short distance
before
this point,
we
recommend to unravel the first
seem and to start all over again.
In
this manner you avoid ugly bunching
of stitches and faulty seams which are accepted only with extremely cheap
quality
articles.
•The
hand crank must be turned only when the
machine
has stopped by
itself, i.e. not in those cases where it has stopped as a result
of
a torn
belt
or a
breakdown
of the
power
supply.
If, in cose of needle breakage, etc., the machine was stopped by actuating
hand stop lever 15 and was cranked to Its sfarting position (crank
B),
the
knife must be prevented from cutting by pressing down extension v, of
the knife drive connecting rod v.
When
restarting
the machine, or
after
the machine
has
been
idle for
some
time, it is
advisable
to hold
extension
v,
down
for a
few
stitches.
Before storting to
work
on the machine,
make
It a rule to check
whether
the
crank
has
been
turned
and
the
machine
blocked
in
the
meantime.
20
To Next Page
Loading...
Need help?
General
