8
Looper cover
Push the looper cover 7 fully to the right and
then swivel it down. Five types of stitches and
their threading paths are portrayed in color on
the inside of the looper cover.
Note: The electricity supply of the machine is
cut off as soon as the looper cover or swivel
plate 12 is opened, for safety reasons, i.e. se-
wing with the machine is no longer possible.
Waste container
(optional, Order No 2992499381111)
Insert the upper latch of the waste container 45
into the upper slot of the looper cover 7.
Apply pressure to the lower part of the contai-
ner until the lower latches fl ick into place in the
lower slots of the looper cover.
To remove the waste container, repeat this
procedure in the reverse order.
To Next Page
Loading...
Need help?
General
