EasyManuals Logo

Pfaff Cover Style User Manual

Pfaff Cover Style
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
24
Important note on threading
The needle(s) must always be threaded last so
that the needle threads do not run under the
looper thread as seen in drawing 1, but instead
over the looper thread as depicted in drawing
2. Should this sequence not be followed, thread
breakage or missed stitches can occur.
If the looper threads break, you must pull the
needle threads out of the needle eye, rethread
the loopier thread and then rethread the needle
threads.
Changing a spool on a threaded machine
Cut the threads off close to the spool and re-
place with new spools. Tie together the threads
which are still in the machine with the new
threads, and pull the threads out of the needle
eyes. Raise the presser foot. Pull on the needle
threads until the knots are about 6 inches (15
cm) past the last thread guide in front of the
needles. Cut the knots off and pull the threads
through the respective needle eyes. The looper
threads can be pulled continuously past the
looper eye and placed to the left underneath
the presser foot.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pfaff Cover Style and is the answer not in the manual?

Pfaff Cover Style Specifications

General IconGeneral
BrandPfaff
ModelCover Style
CategorySewing Machine
LanguageEnglish

Related product manuals