35
Press the power table 45 downwards into the
designated slot on the looper cover. Close
looper cover.
Note:
Please ensure that the upper overedge looper is
disengaged before attaching the power table 45.
To return the machine to its previous settings
after sewing with the cover stitch or two thread
chainstitch:
Open the looper cover and remove the power
table.
Move the looper disengaging lever to the right,
thus re-engaging the upper overedge looper.
Bring the swiveling stitch width latch into the
basic position (see page 31) and engage the up-
per blade (see page 30).
Push the blade guard into the looper cover and
close the looper cover.
To Next Page
Loading...
Need help?
General
