34
Adjusting the machine to the cover stitch
(Prog. 02) and two thread chainstitch
(Prog. 01)
This is only necessary if you do not want to
trim the fabric edge. Insert the needle(s) (see
page 13) according to the overview of the
threading paths and threading sequences (see
page 26). Open the looper cover and remove
the blade guard 8 by pulling it towards you.
Lower the swiveling stitch width latch (see
page 31) and disengage the upper blade (see
page 30). Ensure that the upper blade is disen-
gaged by turning the handwheel towards you.
Disengage the upper overedge looper. Move
the upper overedge looper 18 into its lowest
position by turning the handwheel towards
you.
Move the looper disengaging lever 9 to the left.
Ensure that the looper is disengaged by turning
the handwheel towards you.
Thread the two thread chainstitch looper and
the cover stitch looper (see pages 18 to 21) and
then the needle(s) (see page 22 and 23).
To Next Page
Loading...
Need help?
General
